Do you want to give your dead plants a new life? As a plant parent, it is not an easy task, and no matter how careful you are, some plants in your collection are not receiving adequate care and attention from your side. Don’t Worry with a few of these Quick Hacks are can Revive Dying Plant; you will be capable of bringing them back!
12 Hacks That Will Revive Dying Plant
Look for signs of survival.
Many signs your plant is dying, and most of them overlap, which can get confusing. However, looking closely at the plant’s roots and leaves will give you a better insight into what the plant is suffering from and what it needs to thrive!
Inspect carefully whether the roots and stems have any signs of life or not. If your plant roots are pliant and firm with green stems, you can still improve the plant. But if you notice brittle roots, mushy, it implies the plant is either dead and can’t be revived.
Identify the problem:
There might be several problems that are letting the plant die. Try to find out the actual culprit. It could be due to lack of nutrition, disease or pest, water, sunlight, etc. If the plant’s roots still good, but the stem is dead, you will be assuming that plant can re-grow from the roots.
Prune the dead parts of the plant:
When you see dormant stems, dead leaves, or brown parts of leaves, Try cutting the dead parts of the plants. Begin with the dried leaves and usually move towards the stems. It’s fair to pluck dead leaves and stems with your hands if possible, don’t pull too hard, or you may break the healthy part of your plant. Go extremely slow and check for the green part while trimming. Pruning enhances the chances of survival for the plant as the same can push all its energy towards those parts that still alive. New parts will grow from the trimmed pieces.
Don’t Cut The Stems Entirely:
Stems have entirely dried out. However, the roots of the plant are yet alive. So, in this case, keep the dried stem still intact to the root height of 2-4 cm over the ground. That is to allow new growth and will eventually come through these stems.
Water them Right
Brown, dry leaves, curled-up, and dry roots are a sign of a thirsty plant. But if you have plants like succulents and cacti, then avoid watering them now and then. Only water them when the topsoil of the container goes completely dry.
If your plants demand more extra water, and you miss watering it every day. Then move your plant away from the sun to a more humid place. If the plant is placed inside your house, one such area is the bathroom.
Move your plant to a more sunny location might be sufficient:
Is your plant getting too much sun? When a plant is lacking sunlight, it will develop smaller pale leaves and weaker stems. Look for dry, brittle leaves and dark or light patches on the leaves. Alternatively, if your plant isn’t receiving enough light, the leaves will be short and pale. Many plants need a lot of sunlight for proper growth. Simply move the plant to a new home with better light conditions.
Get a bigger space:
Sometimes the pot becomes smaller for the plant, and the same tends to die. Transfer the plant to a bigger pot with proper drainage and include fertile soil for its roots to grow up to their full potential.
Try to use filtered water:
In various cases, contaminants in water like fluoride, chloride, etc., produce a terrible impact on a plant’s health. One such example is bamboo; if you are watering bamboo with chlorine, water may kill the bamboo plant. Try to install a tank for collecting rainwater and use this for watering your plants.
Overwatering a plant prevents proper drainage, leading to root rot, a malady that begins the roots to become mushy and brownish-black from a lack of oxygen. Signs of root rot include a slowly wilting plant and leaves that are becoming yellow and falling off. To save a plant from root rot, remove it from the soil and wash the roots clean. Then, cut the diseased tissue of roots and repot the plant again in fresh soil after disinfecting the container.
Feed your plant
If your plant is dying from too much water, stop adding fertilizer to your plant’s soil until it’s completely recovered. The plants’ roots are sensitive and require time to heal.
Often wrong fertilizer or too much fertilizer can also burn the plant’s roots. Though, your plant still requires a nutrient boost to grow. Give your plant some water-soluble fertilizer in a watering can and water your plant.
If you find no living stem, leave, but roots are alive, apply this hack to revive dying plant. First, soak the roots in a Hydrogen Peroxide solution for 2 hours. The hydrogen Peroxide formula is H2O2, and water is H2O, so it has an extra oxygen atom. It is excellent for plants. Soaking your plants in hydrogen peroxide solution is really replicates this natural substance found in raindrops.
After checking the soil top surface for dryness, you add two teaspoons Epsom salt in 500 ml of water whenever you water your plant. Epsom Salt carries hydrated magnesium sulfate, and Magnesium improves the plant’s cell walls which helps to intake the nutrients from the soil by these roots.
You may like: